FORUM HOME > TNM > Help
Combining Circuits

JXlinePosted on 08/02/05 at 17:38:58

Don't know if this is possible or not, but I have two different circuits on two different computers and was wanting to combine them into one cpu within the same TNM install.  I know how to move the one copy over to the other cpu, but I don't know how or if it is even possible to move that circuit over so that they are both run on the same TNM.

So basically, I want one TNM install with both circuits separate (eg. WCW and WWE), but installed within the same TNM.

Thanks for any help you can provide or for even trying to understand what I am asking for!!
Oliver CoppPosted on 08/02/05 at 18:22:50

In theory, you shouldn't do this because it's likely to kill your TNM.

Please send me both and I'll do it for you.

You'll lose your circuit database for one of the circuits, though.
Critic of the DawnPosted on 08/02/05 at 18:38:33

To elaborate slightly on what Oliver said, you'll have to re-hire your roster in the circuit in which you lose the circuit database, put their alignment where you like it, and adjust their pushes to the level you were using previously.  You may also want to write down your roster's heat so you can reconstruct that with Tweakcirc.  Your past results and history will all be there, however.

Eric "Critic of the Dawn"
JXlinePosted on 08/02/05 at 19:01:15

Ok...Thanks for the help guys... think I'll just have 2 installs of TNM with one circuit in each.  

Or I may try doing what Critic suggested.

Thanks Again!!