FORUM HOME > TNM > Help
Updated SE, now my circuits don't run

kicPosted on 09/02/03 at 09:14:35

Howdy. Been out of the loop for a month or so since moving, but I finally figured I'd update things tonight. I grabbed the latest download for SE, let it update my old beta installation (beta 14, if it matters), and now it immediately closes when I try to run one of my circuits.

While I haven't combed through every option, it looks like everything is fine. The only time it does anything unusual is when I try to run one of my circuits (it closes when I choose the circuit to run, not the circuit option from the main menu).

I ran the diagnostic tool and it said everything was fine.

On a hunch, I deleted my plugins and tried to update it again, but I still get the same problem.

Anyone else run into this problem?
Oliver CoppPosted on 09/08/03 at 18:16:08

Did the e-mail reply I sent you help?
Oliver CoppPosted on 09/12/03 at 00:24:55

Just for reference, if TNM closes without an error message, Windows kills it for some odd reason. Usually it helps going into the DOS shell's properties page and putting it into compatibility mode.